FM Systems, Inc.

Company Product

The CM-1 UTP is an adaptor that is used with the CM-1 and CM-2 CAMERA MASTER meters to measure the video levels on twisted pair wire installations.

Product • July 21st, 2011

Company Product

The DCB-1 is a filter used to remove DC from a video signal. This allows Video to be removed from a coaxial cable sharing video and DC Power. This unit is an in-line filter that uses capacitive...

Product • July 21st, 2011

Company Product

Camera-Com is an add-on audio surveillance system used to enhance the security of any CCTV video installation. The addition of audio dramatically improves the response time of security personnel.

Product • July 21st, 2011

Company Product

This unit produces four user defined masking zones on any video channel to create areas of privacy on the video image. The zone is blocked so that operators are unable to see detail in the masked...

Product • July 21st, 2011

Company Product

The VTG V ideo T iming G enerator provides up to ten video sync signals with which to synchronize CCTV cameras in the field.

Product • July 21st, 2011

Company Product

The VLTG-800 V ideo L ine T est G enerator creates a standard NTSC video signal that can be observed on a Monitor to display a series of vertical lines that defines the maximum number of "lines of...

Product • July 21st, 2011

Company Product

These devices transmit and receive alarm and control signals encoded on any video signal. You can insert your contact closure alarm and control signals anywhere a video signal is being used, including...

Product • July 20th, 2011

Company Product

The TPT-4000 T wisted P air T ap Repeater is used to amplify and equalize video from a camera over twisted pair wires. The unit has one video input, a BNC Tap or drop to use for a local monitor and...

Product • July 20th, 2011

Company Product

The V10 Video Distribution Amplifier is a high performance Base-band video amplifier with one input and 10 outputs. This wide-band video Distribution Amplifier is used to split a single video signal...

Product • July 20th, 2011

Company Product

The IP VIDEO SNIFFER is a hand-held meter used to check new installations and trouble shoot existing IP video installations. It instantly displays the communication status of both transmit and receive...

Product • July 19th, 2011

Company Product

The VDA424-UTP V ideo D istribution A mplifier is used to amplify and distribute any B/W or color NTSC, PAL, or CCTV video signal. The unit has two channels of Unshielded Twisted Pair (UTP...

Product • July 19th, 2011

Company Product

The APR474 is an adaptive picture rejuvenator for use in all CCTV video installations to improve the quality of your video images. It has the ability to extend the use of Coax Cable video runs up to...

Product • July 19th, 2011